ATTENTION!
Do not turn off the power of the receiver until the end of the update procedure! Otherwise, the receiver may be damaged!
Return previous version Software will be impossible!
Software update via USB-drive (flash drive)
If your receiver is not connected to a satellite dish, then you can update the software via a USB drive. Before downloading the software to a USB flash drive, it must be formatted in FAT32. In the downloaded files you will also find detailed instructions by installation.
Software update via satellite step by step
To update software via satellite, the receiver must be connected to a tuned satellite dish.
The software update consists of two components: the receiver's main software update and the module software update.
ATTENTION! If you are using a GS C591 or GS C5911 client receiver with the server receiver, you must update the software on the client receiver before updating the server receiver software. Instructions for updating the client receiver.
PROCEDURE:
1.Unplug the receiver's power cord from the outlet, and then plug the receiver back into the mains.
2. Switch the receiver to channel number 333 in the general list.
3. After a few seconds, a message will appear on the screen asking you to update the software as follows:
After the appearance this message select "OK" to start the update.
4. Update progress.
After agreeing to update the receiver software, service messages about the update process will appear on the screen. Updating the receiver software takes about ten minutes.
5. When the update is completed, the receiver will reboot and turn on with the new software version.
ATTENTION! For the GS C592 model receiver, this will complete the upgrade as it does not require a module upgrade.
6. For other models: after turning on the receiver, re-switch it to TV channel 333 in the general list. Within one minute, a message will appear on the screen about the need to update the module software of the following form:
7.After this message appears, select "OK" to start the update. The module software update takes about five minutes.
8. After the module software update is completed, the receiver will automatically reboot.
After the software update is completed, check that the update was successful.
To do this, go to the application " Personal Area” (“Menu” -> “Personal account”) and check the values in the lines “Receiver software version” and “Module software version”.
The update was successful if the following information is displayed:
Receiver software version - 3.15.448
Module software version - 0.0.128
This completes the update of the receiver and module software, and the receiver is ready for further work.
Instructions for updating the software of receivers via the Internet
Make sure your receiver is connected to the Internet before starting the update.
To do this, you need to connect the Internet cable to the appropriate connector on the receiver (Ethernet).
If your receiver model has more than a new version software (software), a message will appear on the TV screen for any TV channel you are watching, prompting you to update the software*. Confirm the start of the update and wait for it to complete.
Please note that the software version number may differ depending on the hardware model.
During the software update, the following information will be displayed on the screen: “Attention! Do not turn off the power of the receiver during the update." Disconnecting the equipment from the mains may cause it to malfunction.
The software update takes about 5 minutes on average, the duration depends on the speed of the Internet connection.
After the update is installed, the receiver will reboot
Please note that if a module software update is also available for your receiver, the TV screen may again prompt you to update, which you will need to confirm. Upon completion of the module software update, the receiver will reboot again, after which it will be ready for further work.
Please note that the module software version number may differ depending on the hardware model.
How to update the tricolor channel list on gs b520, gs b522, gs b521, gs e521l, gs b531m, gs b532m, gs b521h, gs b521hl, gs b531n, gs b534m receivers
To find new channels, do the following.
Equipment for digital television- this is what you can buy in our store. Our company has been operating in the market of terrestrial and satellite equipment since 2003 and we already know most of our customers by sight.
For regular customers of our online store there is a system of discounts, which is calculated automatically according to the coupon number assigned to you personally.
All equipment undergoes pre-sale preparation, namely, it is installed latest version Software for satellite and broadcast consoles. All receivers are tested for performance.
Our company delivers equipment, both in Moscow and throughout Russia. Most courier companies have agreements for reduced shipping rates.
In our online store you can find almost any equipment that you may need to receive satellite and terrestrial television. We tried to make convenient process ordering for any If you plan to order more than one item, but several, then you can use the search in the store and pay attention to related equipment. If you go to pick up equipment for receiving satellite TV, then you should go to the menu tab " Satellite television"if for receiving terrestrial or cable TV, then " Terrestrial television"etc. If you have any questions during the ordering process, you can use online chat, which is located on each page of the online store or order back call.
We hope that in the digital TV online store you will be able to spend a minimum amount of time ordering the required equipment.
Setup wizard, GS B 520 receiver, check.
Settings Wizard - what is this application? Why sometimes this app is buggy. Let's try to figure it out and check everything.
Many of the operator's subscribers who use the GS system at home are having problems. Some of the problems arise from the list of TV programs. In order to set up TV programs, sometimes you need to use applications.
Settings wizard, application for the GS B 520 receiver.
In order to win everything, go to the menu. We are looking for an application - setup wizard. By entering it. It's very easy to do this from the remote.
Setup wizard, on the GS B 520 receiver.
We press OK. We fall into extra menu. Here we are already acting as the receiver offers us. Press the arrow on the remote control down - we get to the search tab.
Next, we have new information. We need to select the operator in the tab. There are options here - FIPS code: 393963, FIPS code: 393963 Siberia. If you leave the item - not selected, the receiver will not set up programs.
We have all chosen, click - continue. The receiver switches to the mode - region selection. Everything is simple here, if you do not have a time shift, then choose the main one. If you have time + from Moscow, choose Ural or Chelyabinsk.
Accordingly, after choosing a region, we go further. Our receiver goes into search mode. But the search itself may not be!
Setup Wizard, on our GS B 520 receiver.
This is because all the settings are in memory and the receiver is simply buggy! This fact already affects the operation of the receiver. Only programmers can fix this here, but they don't need it. Therefore, do a factory reset and find TV channels on a new one. It will be more reliable and the receiver will work better.
Everything is very simple, you need to go through the same steps, the only thing is to wait until the receiver reboots. Everything is clearly shown in our video.
and was amazed - a lot of negative reviews, as if they were written as a blueprint and most likely custom-made from competitors' firms. And what is surprising - many authors sometimes do not even have the slightest idea what they are writing about, mixing and confusing the concepts of Satellite TV and Cable. Not only that, they write a continuous negative about Tricolor in general, without indicating a specific brand and model of the receiver (and there is a large line and manufacturers are very different - Russia, China, etc.), dish diameter (60, 90 or 120 cm), but about transponders generally silent. Most authors refer to the lack of a signal in bad weather - but they do not write who and how they installed and tuned the dish, not a single author provided specific data on the strength and quality of the signal in clear weather and in bad weather! So is it worth trusting such reviews? But from competent settings plates depends very much. So is it worth it to indiscriminately find fault with Tricolor? It may be better to call qualified specialists from a Tricolor service or dealer center and do fine tuning satellite dish to the satellite?
I use satellite equipment Tricolor TV since 2006 and have never regretted it. My first receiver GS7300 And he served flawlessly for 10 years. The picture fell only in a heavy downpour, or in a heavy snowfall. For all these years, I have replaced only the cable (rubbed on the edge of the roof and water got into it) Chinese to Italian. There were no more breakdowns. If any questions arose, everything was resolved through the Technical Support service in the personal account on the Tricolor website - quickly and competently - they helped, usually within a day. In 2016, in May, I changed the obsolete GS 7300 receiver for the Promotion to a more modern one GS B520, while paying the dealer of the company 3999 rubles.
New receiver with a new, convenient remote control, with a remote IR control port, with a USB port on front panel- turned out to be even better and more convenient than before.
I was pleased with the convenient location of the USB port, the connection to the TV receiver via HDMI, the absence of extra buttons and the display on the front panel - (the simpler, the more reliable).
The new receiver heats up less, since the power supply unit is moved outside the body of the device. It has become much lighter in weight and more compact than the previous receiver (I compare with the old GS 7300). The receiver is also equipped with a remote IR - control port - which is also very convenient - now the receiver itself can be put into a bedside table, or placed behind the TV case.
The menu is completely different - more convenient, since all channels are divided into categories - Children's, All-Russian, Cinema, Musical, Radio, etc. I was also pleased with the presence of 20 high-definition channels and the fact that many channels can be watched 2 hours earlier. An HD image with a resolution of 1920x1080i has also become available. Channels can be edited at your discretion and form new groups from them - Favorite, Popular, etc.
The new receiver also has the function of recording programs on a USB flash drive, delayed viewing, distribution of TV broadcasts to smartphones and tablets. I have not yet studied all the innovations - I am gradually mastering. In general, I am satisfied with the new receiver so far - the image quality and sound are excellent. The signal strength is constantly 85 - 87%, but the signal quality is 36% - which does not allow you to watch channels Tricolor TV in any weather with high quality Images.
And one more thing - with a more detailed study of the device, the receiver GS B520- turned out to be not a receiver, but a stripped-down TV set-top box - there are not many in it useful features, they are reduced for the sake of reducing the cost of this set-top box! Yes, and this model of the device was released specifically for the Promotion for the exchange of the old receiving equipment to a new one - so such an underreceiver came out. I recommend everyone to think carefully before switching to this model prefixes from Tricolor TV.
When you first turn on the GS B522 and GS B520 receiver, a welcome window appears on the screen. If necessary, you can set the time and date here. But usually this is not required because the receiver receives the date and time from the satellite.
Press the OK button on the receiver's remote control and go to the "Search Tricolor TV" page.
In this menu, use the "right" "left" buttons to select the operator. For the European part, the operator "Tricolor TV" for Siberia "Tricolor-Siberia". If the cymbal is set up correctly when the operator is selected, the “Strength” and “Quality” scales will be filled.
Use the Down button to select Continue and press OK.
After that, a region selection box appears. Select the region with the up and down buttons and press the OK button. For the European part of the country, the region is "Main". When you select the Ural region, in addition to the channels of the main region, federal channels with broadcasting +2 hours.
After this happens automatic search channels. Upon completion of the search, you just need to click the "OK" button and select the "Save" item.
To re-scan for channels on a tuned receiver:
Press "Menu" and in select the item "Search for Tricolor channels", nClick "Start Search" with the "OK" button
Organization and sorting of channels on GS B522 and GS B520 receivers.
On the this moment Tricolor TV has over 200 different TV channels, and of course you have the ones you love more than the rest. It is much more convenient if all your favorite channels are in one, separate list and you don’t have to search for them among other channels.
To create such a list you need:
Press the "Menu" button on the receiver's remote control and go to the "Applications" section, and in it inSelect the Channel Editor application.
Having entered the channel editor, you will see two columns: the lists of channels are displayed on the right, the channels included in this list are on the left.
To create new list press the red button on the receiver's remote control.
The screen will show screen keyboard. Use the up, down, right, left, and OK buttons to name the new list, then save the name by pressing the blue button.
Now, to add your channels to the new list, select it with the "up" "down" buttons and press "right"
Press the green button on the remote control to display the channel list.
After selecting the channel you want to add to the list, click OK. A green checkmark will appear to the right of the channel indicating that the channel has been added to the list.
After you have selected all channels, just press "exit". The right side of the window now shows the channels you have selected in the correct order.
Now when you display the channel list, you have a new group, by selecting it you will see your added channels.
Unlike earlier models of the receiver, when channels are added to the favorite list, in these models, the numbering of channels changes and corresponds to the order in which they were added to the list. For example, if you add channel 185 first, then it becomes 1 in the list. And when switching channels, the list numbering is now used, and not the channel number that was assigned to it during the initial setup.
Your Tricolor TV GS B520 receiver is set up and ready to go. Enjoy watching.
